[Safety Regulations]

(1) Before using pneumatic tools, please make sure to read this manual thoroughly. Only after fully understanding the content can you use pneumatic tools in the workplace and strictly follow its contents.

[Notice]

Do not exceed the maximum operating pressure (100PSI/7.0BAR/7.0kg/cm2) when using tools. Frequent operation of pneumatic tools in environments exceeding the operating pressure will greatly reduce the service life of the tool itself.

(2) When replacing tools or accessories, please first remove the pneumatic tool from the air source.

(3) Wear goggles, earplugs, and masks as much as possible during operation to maintain personal safety.

(4) Do not wear loose clothing, scarves, ties, or jewelry during operation to avoid being caught up by moving or rotating parts and causing danger.

(5) When connecting pneumatic tools to high-pressure gas sources, do not press the trigger unless in use.

(6) Always ensure the condition of spare parts, loose parts can cause serious danger.

(7) When replacing worn parts, please use specialized parts.

(8) Do not use compressed air tubes that are damaged or impacted.

(9) Do not point tools at yourself or others.

(10) Before use, check if there are any fragile or damaged parts in the air compression tube. If any of the above conditions are found, please update immediately to maintain safety.

(11) Tighten all nuts and screws, and ensure that all equipment is in a safe state.

Moderate lubrication is the responsibility of the tool user. Compressed air can condense water vapor, which can easily cause rust. Without proper lubrication, the lifespan of pneumatic tools can be greatly shortened.

[Attention]

Pneumatic tools need to be lubricated before and after use.

Lubrication of the air motor section-

The air motor needs to be lubricated daily, but not too many times.

[Notice]

Please remove the tool from the high-pressure air source before lubrication.

(1) Remove the tool from the high-pressure area.

(2) Press the trigger and add 3-5 cc of pneumatic tool specific oil from the intake head. Connect the tool to a high-pressure air source and place a piece of cloth or towel on the exhaust hood. Start the tool, forward and reverse for 20-30 seconds each. When the high-pressure gas is connected, the lubricating oil will be discharged from the rear exhaust hole.

Lubrication of the impact frame assembly (butter)

The impact frame assembly needs to be lubricated and maintained once a week.

(1) Remove the tool from the air duct.

(2) Remove the screws on the front cover (or simply loosen the front cover) and clean the remaining butter inside the front cover and on the impact bracket assembly.

(3) Apply an appropriate amount of butter on the impact bracket assembly, and then lock the front cover.

(4) Connect the air pressure tube and gently start the trigger to idle for 20-30 seconds to lubricate the entire impact unit with butter.

matters needing attention

(1) Do not remove more parts that require repair or replacement during disassembly and assembly.

(2) Please be careful to avoid damaging tools or parts during disassembly and assembly.

(3) No impurities are allowed to enter during disassembly.